Jump to content

Stuck on 99% Verifying every time


Recommended Posts

Hi,

I've just downloaded version 4.5.1.3868 to my new Notebook PC, running Windows 8, 64 bit. It burns OK, but verifying always stops at 99%.

I'm burning data DVDs at 8x speed on a HL-DT-ST DVDRAM optical drive.

When I run CheckCD v 3.1.14.0 (not your software) each DVD checks out OK, but does come up with the message (not defined as an error):

"note; hash; For at least one file only file readability was tested because no valid hash file was found (code: 54);"

Regards,

seamon53

Link to post
Share on other sites

I don't see how to attach the log file to this message. I will send it via email.

However, I can tell you what is happening.

Verify does reach 100%, however the information it is presenting is erroneous.

At 8x, it takes around 11 minutes to burn 4 gig of data, then Verify almost immediately goes to 99% and says Time Remaining is less than 1 minute. At this point, both the percent verified and the Time Remaining are NOT correct.

Usually it take almost an equal amount of time to verify as it does to burn. So, at a total of 20 minutes, I'm thinking "this is stuck at 99%" since it has been there for almost 10 minutes. However, had I waited a few more minutes, it would have reached 100%.

Regards

seamon53

Link to post
Share on other sites
  • 6 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.